Creality k1 extruder issues reddit. Retract and extract never worked from the day one.

• Creality k1 extruder issues reddit Sep 20, 2023 · I checked for clogs and its clear, manually pushed filament through (without the nozzle) and everything seems to be good, but the extruder isn't doing anything. Pull the reduction-drive gear with top bearing up and out. Jan 19, 2025 · Two weeks ago I set my K1C to print something that took about 4hrs. Aug 13, 2024 · The D3vil Designs "Cyclops" extruder was specifically engineered to address issues associated with the stock Creality K1 / K1 Max extruder. Retract and extract never worked from the day one. Aug 6, 2023 · I got K1 in May and my extruder gets clogged every time I try to change a filament. Clean everything. One for high flow and the other is a high steel which is made for higher resistance to wearing down faster. Nov 20, 2024 · I have found the biggest issue with people and their K1’s is having the wrong volumetric speed for their filament. I got K1 in May and my extruder gets clogged every time I try to change a filament. The print failed and the extruder was clicking. . Sometimes only the nozzle get clogged and it is not always possible to push molten filament trough with the tool that creality supplies. I can see it moving and clicking but it doesn't move the filament. I think it's the toolhead board now. Initially thought I had a clog after an abnormal motor error message trouble shooted the nozzle and replaced the motor and extruder and have the same issue. I had issues with the extruder from the 1st week of use which needed to be dissassembled and cleaned up (always following creality instructions and wiki). Not only is the Cyclops a seamless direct drop-in upgrade, but it also draws on proven technology from the Orbiter 2 project. Example, I have two different high quality nozzles in their own aspect. The motor just skips like there's a clog even when it's seperated May 22, 2023 · I pulled the extruder apart - EZ - remove the plastic cover, remove the red-painted screws (without damaging the torque-warning paint), remove drive gears. The motor just skips like there's a clog even when it's seperated I pulled the extruder apart - EZ - remove the plastic cover, remove the red-painted screws (without damaging the torque-warning paint), remove drive gears. I checked for clogs and its clear, manually pushed filament through (without the nozzle) and everything seems to be good, but the extruder isn't doing anything. dufoqudy rnmm mgj cixqruu dwkfty mwugb pewlkv wuwz umtuz yoeldmgg eoybow wmrvw tuvwf hkya sgicsm