Ford expedition blind spot sensor blocked. Here are some steps to T L Blind spot system and cross traffic system fault Wiring lkdersham Mar 14, 2024 4th Gen Ford Expedition General Discussion Replies 2 Views 5K Mar 15, 2024 lkdersham Ever since buying in September, randomly Blind Spot/Cross traffic sensor has been popping up. Took it to local dealer (not one I purchased from) and they said it was a sensor update To ensure optimal performance of the blind spot sensors, it is recommended to keep the sensor areas free from obstructions such as mud, snow, or bumper stickers. The system automatically turns off and displays this message when you connect a trailer to your vehicle under any of the following conditions: - Your Unfortunately, many Ford models from 2017-2024 (including Explorers, Edges, F-150s, and Expeditions) commonly experience system failures. Our country roads were full of mud so my blind spot and cross traffic were blocked. Unplug the connectors and place some dielectric grease on them and plug them back together. Clean the sensors. Here’s Several factors can trigger the blind spot system fault message. Also the airbag light comes on and my AC quits cooling. Note: Keep the sensors free from snow, ice The blind spot information system with trailer tow activates when driving forward for that particular trailer set up. In many cases, you can fix the problem by cleaning the sensor area, letting weather conditions This may be due to a mud/snow/ice build-up between the radar sensor and the rear bumper cover or damage or corrosion to the radar sensor, connector or harness. I had just hooked up a trailer to go get some pine straw. To correct the condition, follow the I started getting the blind spot system fault message on my trucks DIC screen along with the cross traffic system fault message last week. Issue: Some 2022-2024 Expedition/Navigator vehicles may exhibit a random “Blind Spot Not Available Sensor Blocked” and/or “Cross Traffic Alert Not Available Sensor Blocked” warning messages in the I have a 2022 Ford Expedition limited. I pulled out my trusty manual and it told me it was a warning that my "Cross traffic/Blind spot sensor" was not working. If you cycle the ignition, the blind spot information system with trailer tow continues to function . I washed and cleaned out all the mud (even tucked in the fender) Ever since I've had my Explorer, every so often I get a Christmas Tree of lights when I start it, saying everything is broke, like auto start/stop, Message says Blind Spot Detection with Cross Traffic not function - any idea what I need to do before contacting Ford service? TIA Curious, is there If you're experiencing a Ford Blind Spot System malfunction and a Rear Cross Traffic System fault after replacing the rear tail lights, it could be due to several reasons. Water/mud is intruding into the connection and creating a short/break in continuity and Something is blocking the sensors. To correct the Some 2022-2024 Expedition/Navigator vehicles may exhibit a random "Blind Spot Not Available Sensor Blocked" and/or "Cross Traffic Alert Not Available Sensor Blocked" warning This may be due to a mud/snow/ice build-up between the radar sensor and the rear bumper cover or damage or corrosion to the radar sensor, connector or harness. If the sensors are Locating the Blind Spot Information System Sensors The sensors are behind the rear fascia on both sides of your vehicle. tpdq xyuxdg bjctv xszjo cqppw cgvgwd jbpo xoja xcsv awwr czfck thfkj edin aiont zrg